Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 111

Chapter 7 Configuring IEEE 802.1Q Tunneling
To remove global support for 802.1Q tunneling on the switch, perform this task in privileged mode:
Task
Step 1
Remove tunneling support on the switch.
Step 2
Verify the configuration.
This example shows how to remove tunneling support on the switch and verify the configuration:
Console> (enable) set dot1q-all-tagged disable
Dot1q tagging is disabled
Console> (enable) show dot1q-all-tagged
Dot1q all tagged mode disabled
Console> (enable)
78-13315-02
Command
set dot1q-all-tagged disable [all]
show dot1q-all-tagged
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Support for 802.1Q Tunneling
7-5