Enabling Vtp Version 2 - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring VTP
This example shows how to configure the switch as VTP transparent and verify the configuration:
Console> (enable) set vtp mode transparent
VTP domain Lab_Net modified
Console> (enable) show vtp domain
Domain Name
-------------------------------- ------------ ----------- ----------- ----------
Lab_Net
Vlan-count Max-vlan-storage Config Revision Notifications
---------- ---------------- --------------- -------------
10
Last Updater
--------------- -------- -------- -------------------------
172.20.52.70
Console> (enable)

Enabling VTP Version 2

VTP version 2 is disabled by default on VTP version 2-capable switches. When you enable VTP
version 2 on a switch, every VTP version 2-capable switch in the VTP domain will enable version 2 as
well.
VTP version 1 and VTP version 2 are not interoperable on switches in the same VTP domain. Every
Caution
switch in the VTP domain must use the same VTP version. Do not enable VTP version 2 unless every
switch in the VTP domain supports version 2.
In a Token Ring environment, you must enable VTP version 2 for Token Ring VLAN switching to
Note
function properly.
To enable VTP version 2, perform this task in privileged mode:
Task
Step 1 Enable VTP version 2 on the switch.
Step 2
Verify that VTP version 2 is enabled.
This example shows how to enable VTP version 2 and verify the configuration:
Console> (enable) set vtp v2 enable
This command will enable the version 2 function in the entire management domain.
All devices in the management domain should be version2-capable before enabling.
Do you want to continue (y/n) [n]? y
VTP domain Lab_Net modified
Console> (enable) show vtp domain
Domain Name
-------------------------------- ------------ ----------- ----------- ----------
Lab_Net
Vlan-count Max-vlan-storage Config Revision Notifications
---------- ---------------- --------------- -------------
10
Last Updater
--------------- -------- -------- -------------------------
172.20.52.70
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
10-8
Domain Index VTP Version Local Mode
1
1023 0
V2 Mode Pruning
disabled disabled 2-1000
Domain Index VTP Version Local Mode
1
1023 1
V2 Mode Pruning
enabled disabled 2-1000
2
enabled
PruneEligible on Vlans
Command
set vtp v2 enable
show vtp domain
2
enabled
PruneEligible on Vlans
Chapter 10 Configuring VTP
Password
Transparent -
Password
server -
78-13315-02