Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 440

Configuring Authentication
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Disabling RADIUS Authentication
When local authentication is disabled and only RADIUS authentication is enabled, if you disable
RADIUS authentication, local authentication is reenabled automatically.
To disable RADIUS authentication, perform this task in privileged mode:
Task
Step 1 Disable RADIUS authentication for login mode.
Step 2 Disable RADIUS authentication for enable mode. set authentication enable radius disable [all |
Step 3 Verify the RADIUS configuration.
This example shows how to disable RADIUS authentication:
Console> (enable) set authentication login radius disable
radius login authentication set to disable for console and telnet session.
Console> (enable) set authentication enable radius disable
radius enable authentication set to disable for console and telnet session.
Console> (enable) show authentication
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
21-30
Telnet Session
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
0 minutes
2
5 seconds
Status Auth-port
------------
primary 1812
Command
set authentication login radius disable [all |
console | http | telnet]
console | http | telnet]
show authentication
Console Session Telnet Session
---------------- ----------------
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Telnet Session
disabled disabled
disabled disabled
enabled(primary) enabled(primary)
Chapter 21 Configuring Switch Access Using AAA
78-13315-02