Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 40

Catalyst Command-Line Interface
Accessing the MSFC from the Console Port
You can enter the switch console command to access the MSFC from the switch CLI directly connected
to the supervisor engine console port. To exit from the MSFC CLI and return to the switch CLI, enter
^C^C^C at the Router> prompt.
To access the MSFC from the switch CLI, perform this task:
Task
Access the MSFC from the switch CLI.
1. The mod keyword specifies the module number of the MSFC; either 15 (if the MSFC is installed on the supervisor engine in
To access the Cisco IOS CLI on the standby MSFC, connect to the console port of the standby
Note
supervisor engine.
This example shows how to access the active MSFC from the switch CLI from the active supervisor
engine, and how to exit the MSFC CLI and return to the switch CLI:
Console> (enable) switch console 15
Trying Router-15...
Connected to Router-15.
Type ^C^C^C to switch back...
Router> ^C^C^C
Console> (enable)
Accessing the MSFC from a Telnet Session
You can enter the session mod command to access the MSFC from the switch CLI using a Telnet session.
To exit from the MSFC CLI back to the switch CLI, enter the exit command at the Router> prompt.
The supervisor engine software sees the MSFC as module 15 (when installed on a supervisor engine
Note
in slot 1) or module 16 (when installed on a supervisor engine in slot 2).
This example shows how to access the MSFC from the switch CLI, and how to exit the MSFC CLI and
return to the switch CLI:
Console> (enable) session 15
Router> exit
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
2-4
slot 1) or 16 (if the MSFC is installed on the supervisor engine in slot 2). If no module number is specified, the console will
switch to the MSFC on the active supervisor engine.
Chapter 2
Command
1
switch console [mod]
Command-Line Interfaces
78-13315-02