Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 503

Catalyst 6000 series software configuration guide
Hide thumbs Also See for WS-X6066-SLB-APC - Content Switching Module:
Table of Contents

Advertisement

Chapter 22
Configuring Redundancy
Router(config-if)# standby 21 priority 109
Router(config-if)# standby 21 preempt
Router(config-if)# standby 21 timers 5 15
Router(config-if)# standby 21 authentication Secret
Router(config-if)# ^Z
Router# ^C^C^C
This example shows how to configure HSRP on the MSFC in Switch S2:
Console> (enable) switch console 15
Trying Router-15...
Connected to Router-15.
Type ^C^C^C to switch back...
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface vlan10
Router(config-if)# standby 10 ip 172.20.100.10
Router(config-if)# standby 10 priority 109
Router(config-if)# standby 10 preempt
Router(config-if)# standby 10 timers 5 15
Router(config-if)# standby 10 authentication Secret
Router(config-if)# interface vlan21
Router(config-if)# standby 21 ip 192.20.100.21
Router(config-if)# standby 21 priority 110
Router(config-if)# standby 21 preempt
Router(config-if)# standby 21 timers 5 15
Router(config-if)# standby 21 authentication Secret
Router(config-if)# ^Z
Router# ^C^C^C
Example 2—Single Chassis with Dual Supervisor Engines and MSFCs
In the example in
configured on the MSFCs.
Figure 22-6 Single Chassis with Redundant Supervisors and MSFCs
VLAN 10
This example shows how to configure HSRP on the MSFC in Switch S1:
Console> (enable) switch console 15
Trying Router-15...
Connected to Router-15.
Type ^C^C^C to switch back...
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface vlan10
Router(config-if)# standby 10 ip 172.20.100.10
78-13315-02
Figure
22-6, high availability is configured on the supervisor engines, and HSRP is
VLAN 21
Slot 1
Sup#1(active)/MSFC#1
HSRP Active VLAN 10: priority 110
HSRP Standby VLAN 21: priority 109
Slot 2
Switch S1
Sup#2(standby)/MSFC#2
HSRP Active VLAN 21: priority 110
HSRP Standby VLAN 10: priority 109
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
End with CNTL/Z.
End with CNTL/Z.
MSFC Redundancy
22-29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents