Forcing A Switchover To The Standby Supervisor Engine - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring Redundant Supervisor Engines
Console> (enable) show test 2
Module 2 : 2-port 1000BaseX Supervisor
Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Unknown)
ROM:
Line Card Status for Module 1 : PASS
Port Status :
Ports 1
-----------
Line Card Diag Status for Module 2
Module 2
Cafe II Status :
Loopback Status [Reported by Module 2] :
Ports 1
-----------
Console> (enable)

Forcing a Switchover to the Standby Supervisor Engine

You can force a switchover to the standby supervisor engine by resetting the active supervisor engine.
Resetting the active supervisor engine disconnects any open Telnet sessions.
Note
To force a switchover to the standby supervisor engine, perform this task in privileged mode:
Task
Reset the active supervisor engine (where mod is
the number of the active supervisor engine).
In addition, you can also force a switchover to the standby supervisor engine by setting the
CISCO-STACK-MIB moduleAction variable to reset(2) on the active supervisor engine. When the
switchover occurs, the system sends a standard SNMP warm-start trap to the configured trap receivers.
This example shows the console output on the active supervisor engine when you force a switchover
from the active to the standby supervisor engine:
Console> (enable) reset 1
This command will force a switch-over to the standby Supervisor module.
Do you want to continue (y/n) [n]? y
Console> (enable) 12/07/1998,17:04:39:SYS-5:Module 1 reset from Console//
System Bootstrap, Version 3.1(2)
Copyright (c) 1994-1997 by cisco Systems, Inc.
System Bootstrap, Version 3.1(2)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
22-6
. Flash-EEPROM: . Ser-EEPROM: .
2
. .
NewLearnTest:
IndexLearnTest:
DontForwardTest:
DontLearnTest:
ConditionalLearnTest:
BadBpduTest:
TrapTest:
2
. .
NVRAM: .
(. = Pass, F = Fail, N = N/A)
.
.
.
.
.
.
.
Command
reset mod
Chapter 22 Configuring Redundancy
EOBC Comm: .
78-13315-02