Disabling Ntp - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring NTP
This example shows how to clear an NTP server address from the NTP server table:
Console> (enable) clear ntp server 172.16.64.10
NTP server 172.16.64.10 removed.
Console> (enable)

Disabling NTP

To disable NTP broadcast-client mode on the switch, perform this task in privileged mode:
Task
Step 1 Disable NTP broadcast-client mode.
Step 2
Verify the NTP configuration.
This example shows how to disable NTP client mode on the switch:
Console> (enable) set ntp broadcastclient disable
NTP Broadcast Client mode disabled
Console> (enable)
To disable NTP client mode on the switch, perform this task in privileged mode:
Task
Step 1 Disable NTP client mode.
Step 2
Verify the NTP configuration.
This example shows how to disable NTP client mode on the switch:
Console> (enable) set ntp client disable
NTP Client mode disabled
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
31-8
Chapter 31
Command
set ntp broadcastclient disable
show ntp [noalias]
Command
set ntp client disable
show ntp [noalias]
Configuring NTP
78-13315-02