Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 329

Chapter 16 Configuring Access Control
Configuring VACLs
This example shows how to commit the ACEs to NVRAM:
Console> (enable) commit security acl all
ACL commit in progress.
ACL IPXACL1 is committed to hardware.
Console> (enable)
Enter the show security acl info IPXACL1 command to verify that the changes were committed. If this
VACL has not been mapped to a VLAN, enter the set security acl map command to map it to a VLAN.
This example shows how to create an ACE for IPXACL1 to allow all traffic from source network 1 and
insert this ACE before ACE number 2:
Console> (enable) set security acl ipx IPXACL1 permit any 1 before 2
IPXACL1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable)
This example shows how to create an ACE for IPXACL1 to allow traffic from all source addresses:
Console> (enable) set security acl ipx IPXACL1 permit any any
IPXACL1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable)
This example shows how to display the contents of the edit buffer:
Console> (enable) show security acl info IPXACL1 editbuffer
set security acl ipx IPXACL1
-----------------------------------------------------------------
1. deny any 1234
2. permit any 1
3. deny any any 1.A.3.4
4. redirect 4/1 any 3456
5. permit any any
ACL IPXACL1 Status: Not Committed
Console> (enable)
This example shows how to commit the ACEs to NVRAM:
Console> (enable) commit security acl all
ACL commit in progress.
ACL IPXACL1 is committed to hardware.
Console> (enable)
For more information about the commit security acl all command, see the "Committing ACLs"
Note
section on page 16-35.
Enter the show security acl info IPXACL1 command to verify that the changes were committed. If this
VACL has not been mapped to a VLAN, enter the set security acl map command to map it to a VLAN.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
16-33
78-13315-02