Setting The System Contact And Location - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 20 Administering the Switch
Setting the Static System Prompt
To set the static system prompt, perform this task in privileged mode:
Task
Set the static system prompt.
This example shows how to set the static system prompt on the switch:
Console> (enable) set prompt Catalyst6509>
Catalyst6509> (enable)
Clearing the System Name
To clear the system name, perform this task in privileged mode:
Task
Clear the system name.
This example shows how to clear the system name:
Console> (enable) set system name
System name cleared.
Console> (enable)

Setting the System Contact and Location

You can set the system contact and location to help you with resource management tasks.
To set the system contact and location, perform this task in privileged mode:
Task
Step 1 Set the system contact.
Step 2 Set the system location.
Step 3 Verify the global system information.
This example shows how to set the system contact and location and verify the configuration:
Catalyst 6000> (enable) set system contact sysadmin@corp.com
System contact set.
Catalyst 6000> (enable) set system location Sunnyvale CA
System location set.
Catalyst 6000> (enable) show system
PS1-Status PS2-Status Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- ---------- ---------- -------------- ---------
ok
78-13315-02
none ok off
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Setting the System Contact and Location
Command
set prompt prompt_string
Command
set system name
Command
set system contact [contact_string]
set system location [location_string]
show system
ok 0,04:04:07 20 min
20-3