Displaying Qos Information; Reverting To Qos Defaults; Disabling Qos - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 14 Configuring QoS

Displaying QoS Information

To display QoS information, perform this task:
Task
Display QoS information.
This example shows how to display the current QoS configuration information for the switch:
Console> show qos info config
QoS setting in NVRAM:
QoS is enabled
All ports have 2 transmit queues with 1 drop thresholds (2q1t).
Default CoS = 4
Queue and Threshold Mapping:
Queue Threshold CoS
----- --------- ---------------
1
2
Console>

Reverting to QoS Defaults

To revert to QoS defaults, perform this task in privileged mode:
Task
Revert to QoS defaults.
This example shows how to revert to QoS defaults:
Console> (enable) clear qos config
This command will disable QoS and take values back to factory default.
Do you want to continue (y/n) [n]? y
QoS config cleared.
Console> (enable)
Reverting to defaults disables QoS, because QoS is disabled by default.
Note

Disabling QoS

To disable QoS, perform this task in privileged mode:
Task
Disable QoS on the switch.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
1 0 1 2 3
1 4 5 6 7
Command
show qos info [runtime | config]
Command
clear qos config
Command
set qos disable
Configuring QoS on the Switch
14-7