Configuring Rspan - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring RSPAN

Destination
Admin Source
Oper Source
Direction
Incoming Packets: enabled
Learning
Multicast
Filter
Console> (enable)
This example shows how to set port 3/2 as the SPAN source and port 2/2 as the SPAN destination:
Console> (enable) set span 3/2 2/2 tx create
Destination
Admin Source
Oper Source
Direction
Incoming Packets: disabled
Destination
Admin Source
Oper Source
Direction
Incoming Packets: disabled
Learning
Multicast
Filter
Console> (enable)
To disable SPAN, perform this task in privileged mode:
Task
Disable SPAN on the switch.
This example shows how to disable SPAN on the switch:
Console> (enable) set span disable 2/1
This command will disable your span session.
Do you want to continue (y/n) [n]?y
Disabled port 2/1 to monitor transmit traffic of VLAN 522
Console> (enable)
Configuring RSPAN
These sections describe how to configure RSPAN:
•
•
•
•
•
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
38-8
: Port 2/12
: VLAN 522
: Port 2/1-2
: transmit
: enabled
: enabled
: -
: Port 2/1
: port 3/1
: Port 3/1
: transmit/receive
: Port 2/2
: port 3/2
: Port 3/2
: transmit
: enabled
: enabled
: -
RSPAN Hardware Requirements, page 38-9
Understanding How RSPAN Works, page 38-9
RSPAN Configuration Guidelines, page 38-10
Configuring RSPAN, page 38-11
RSPAN Configuration Examples, page 38-14
Chapter 38 Configuring SPAN and RSPAN
Command
set span disable [dest_mod/dest_port | all]
78-13315-02