Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 282

Configuring MLS
Using Debug Commands on the SCP
Table 14-10
SCP that runs over the Ethernet out-of-band channel (EOBC).
Table 14-10 SCP Debug Commands
Command
[no] debug scp async
[no] debug scp data
[no] debug scp errors
[no] debug scp packets
[no] debug scp timeouts
[no] debug scp all
Displaying Global IP MMLS Information on the Supervisor Engine
These sections describe how to configure IP MMLS on Supervisor Engine 1:
•
•
•
•
IP MMLS is permanently enabled on Supervisor Engine 1 and cannot be disabled.
Note
To configure IP MMLS on the MSFC, see the
Note
page
Displaying IP MMLS Configuration Information
The show mls multicast command displays global IP MMLS configuration information and the state of
participating MSFCs.
To display global IP MMLS configuration information, perform this task:
Task
Display global IP MMLS configuration
information.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
14-34
describes the Serial Control Protocol (SCP)-related debug commands to troubleshoot the
Displaying IP MMLS Configuration Information, page 14-34
Displaying IP MMLS Statistics, page 14-35
Clearing IP MMLS Statistics, page 14-36
Displaying IP MMLS Entries, page 14-36
14-28.
Description
Displays trace for asynchronous data in and out of the SCP
system.
Shows packet data trace.
Displays errors and warnings in the SCP.
Displays packet data in and out of the SCP system.
Reports timeouts.
Turns on all SCP debugging messages.
"Configuring IP MMLS on the MSFC" section on
Command
show mls multicast
Chapter 14 Configuring MLS
78-13315-02