Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 219

Chapter 12 Configuring InterVLAN Routing
To check which MSM interfaces are currently auto stated, perform this task in enabled mode:
Task
Check which MSM interfaces are currently auto
stated.
This example shows how to check which MSM interfaces are currently auto stated (shutdown or brought
up through auto state):
Router# show autostate entries
Port-channel1.5
Port-channel1.6
Port-channel1.4
Router#
Disabling the Auto State Feature
To disable the auto state feature if you have an MSM installed, perform this task in privileged mode:
Task
Disable the auto state feature if you have an MSM
installed.
The auto state feature is enabled by default. This example shows how to disable the auto state feature if
you have an MSM installed:
Console> (enable) set msmautostate disable
MSM port auto state disabled.
Console> (enable)
To disable the line protocol state determination of the MSFC, perform this task in privileged mode:
If you toggle (enable to disable and/or disable to enable) the msfcautostate command you might have
Note
to use the shutdown and no shutdown commands to disable and then restart the VLAN and WAN
interfaces on the MSFC to bring them back up. Unless there is a valid reason, the MSFC auto state
feature should not be disabled.
Task
Disable the line protocol state determination of
the MSFC.
This example shows how to disable the line protocol state determination of the MSFC:
Console> (enable) set msfcautostate disable
MSM port auto state disabled.
Console> (enable)
78-13315-02
Command
show autostate entries
Command
set msmautostate disable
Command
set msfcautostate disable
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring InterVLAN Routing on the MSFC
12-7