Configuring Multicast Groups; Clearing Multicast Router Ports - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 40 Configuring Multicast Services

Configuring Multicast Groups

To configure a multicast group manually, perform this task in privileged mode:
With software release 6.3(2) and later releases, the maximum number of Layer 2 multicast entries is
Note
15488.
Task
Step 1 Add one or more multicast MAC addresses to the
CAM table.
Step 2 Verify the multicast group configuration.
This example shows how to configure multicast groups manually and verify the configuration (the
asterisks indicate the entry was manually configured):
Console> (enable) set cam static 01-00-11-22-33-44 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-11-22-33-44-55 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-22-33-44-55-66 2/6-12
Static multicast entry added to CAM table.
Console> (enable) set cam static 01-33-44-55-66-77 2/6-12
Static multicast entry added to CAM table.
Console> (enable) show multicast group
IGMP disabled
VLAN
----
1
1
1
1
Total Number of Entries = 4
Console> (enable)

Clearing Multicast Router Ports

To clear manually configured multicast router ports, perform one of these tasks in privileged mode:
Task
Clear specific, manually configured multicast
router ports.
Clear all manually configured multicast router
ports.
This example shows how to clear a manually configured multicast router port entry:
Console> (enable) clear multicast router 2/12
Port 2/12 cleared from multicast router port list.
Console> (enable)
78-13315-02
Dest MAC/Route Des Destination Ports or VCs / [Protocol Type]
------------------ ----------------------------------------------------
01-00-11-22-33-44* 2/6-12
01-11-22-33-44-55* 2/6-12
01-22-33-44-55-66* 2/6-12
01-33-44-55-66-77* 2/6-12
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Multicast Router Ports and Group Entries
Command
set cam {static | permanent} multicast_mac
mod/port [vlan]
show multicast group [mac_addr] [vlan_id]
Command
clear multicast router mod/port
clear multicast router all
40-21