Mapping A Cos Value To A Host Destination Mac Address/Vlan Pair; Deleting A Cos Value To A Host Destination Mac Address/Vlan Pair - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 41 Configuring QoS
This example shows how to detach an ACL named my_acl from port 2/1:
Console> (enable) clear qos acl map my_acl 2/1
Hardware programming in progress...
ACL my_acl is detached from port 2/1.
Console> (enable)
This example shows how to detach an ACL named my_acl from VLAN 4:
Console> (enable) clear qos acl map my_acl 4
Hardware programming in progress...
ACL my_acl is detached from vlan 4.
Console> (enable)
The default ACLs cannot be detached from any interfaces.
Note

Mapping a CoS Value to a Host Destination MAC Address/VLAN Pair

QoS only supports this command with a Layer 2 Switching Engine.
Note
To map a CoS value to all frames destined for a particular host destination MAC address and VLAN
number value pair, perform this task in privileged mode:
Task
Step 1 Map a CoS value to a host destination MAC
address/VLAN pair.
Step 2 Verify the configuration.
This example shows how to map CoS 2 to a destination MAC address and VLAN 525:
Console> (enable) set qos mac-cos 00-40-0b-30-03-48 525 2
CoS 2 is assigned to 00-40-0b-30-03-48 vlan 525.
Console> (enable)

Deleting a CoS Value to a Host Destination MAC Address/VLAN Pair

Note QoS only supports this command with a Layer 2 Switching Engine.
To delete a host destination MAC address and VLAN number value pair CoS assignment, perform this
task in privileged mode:
Task
Step 1 Delete a host destination MAC address and
VLAN number value pair CoS assignment.
Step 2 Verify the configuration.
78-13315-02
Command
set qos mac-cos dest_mac VLAN cos_value
show qos mac-cos {dest_mac [vlan] | all}
Command
clear qos mac-cos {dest_mac [vlan] | all}
show qos mac-cos {dest_mac [vlan] | all}
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring QoS
41-47