Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 703

Chapter 40 Configuring Multicast Services
Task
Enable RGMP.
Disable RGMP.
This example shows how to enable RGMP:
Console> (enable) set rgmp enable
RGMP enabled.
Console> (enable)
This example shows how to disable RGMP:
Console> (enable) set rgmp disable
RGMP disabled.
Console> (enable)
Displaying RGMP Group Information
Use these commands to display all multicast groups that were joined by one or more RGMP-capable
routers and to display the count of multicast groups that were joined by one or more RGMP-capable
routers.
To display RGMP group information, perform these tasks in privileged mode:
Task
Display all multicast groups that were joined by
one or more RGMP-capable routers.
Display the count of multicast groups that were
joined by one or more RGMP-capable routers.
This example shows how to display RGMP group information:
Console> (enable) show rgmp group
VlanDest MAC/Route DesRGMP Joined Router Ports
---------------------------------------------------------------------------------------
101-00-5e-00-01-285/1,5/15
101-00-5e-01-01-015/1
201-00-5e-27-23-70*3/1, 5/1
Total Number of Entries = 3
'*' - Configured
Console> (enable)
Console> (enable) show rgmp group count 1
Total Number of Entries = 2
Displaying RGMP VLAN Statistics
To display RGMP statistics for a given VLAN, perform this task in privileged mode:
78-13315-02
Command
set rgmp enable
set rgmp disable
Command
show rgmp group [mac_addr] [vlan_id]
show rgmp group count [vlan_id]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring RGMP
40-23