Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 269

Chapter 14 Configuring MLS
Displaying MLS Information
The show mls command displays protocol-specific MLS information and MSFC-specific information.
To display protocol-specific MLS information and MSFC-specific information, perform this task:
Task
Display general IP or IPX MLS
information and MSFC-specific
information for all MSFCs.
1. The mod keyword specifies the module number of the MSFC; either 15 (if the MSFC is installed on Supervisor Engine 1 in
This example shows how to display IP MLS information and MSFC-specific information:
Console> (enable) show mls ip
Total Active MLS entries = 0
Total packets switched = 0
IP Multilayer switching enabled
IP Multilayer switching aging time = 256 seconds
IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0
IP Flow mask: Full Flow
Configured flow mask is Destination flow
Active IP MLS entries = 0
Netflow Data Export version: 8
Netflow Data Export disabled
Netflow Data Export port/host is not configured
Total packets exported = 0
MSFC ID
--------------- ------ ---- ----------------- --------------------
52.0.03
Console> (enable)
This example shows how to display IPX MLS information:
Console> (enable) show mls ipx
IPX Multilayer switching aging time = 256 seconds
IPX flow mask is Destination flow
IPX max hop is 15
Active IPX MLS entries = 356
IPX MSFC ID
--------------- ------ ---- ----------------- ----------------
22.1.0.56
78-13315-02
slot 1) or 16 (if the MSFC is installed on Supervisor Engine 1 in slot 2).
Module XTAG MAC
15 1
Module XTAG MAC
15 1
Command
show mls {ip | ipx} [mod
Vlans
01-10-29-8a-0c-00 1,10,123,434,121
222,666,959
Vlans
00-10-07-38-29-18 2,3,4,5,6,
7,8,9,10,11,
12,13,14,15,16,
17,18,19,20,66,
77
00-d0-d3-9c-e3-f4 25
00-10-07-38-29-18 26,111
00-d0-d3-9c-e3-f4 112
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring MLS
1
]
14-21