Configuring Tacacs+ Authentication - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 21 Configuring Switch Access Using AAA
At the "Enter Password" prompt, press Return. The login password is null for 30 seconds when you are
Step 3
connected to the console port.
Step 4 Enter privileged mode using the enable command.
At the "Enter Password" prompt, press Return. (The enable password is null for 30 seconds when you
Step 5
are connected to the console port.)
Step 6 Enter the set password or set enablepass command, as appropriate.
Step 7 When prompted for your old password, press Return.
Enter and confirm your new password.
Step 8

Configuring TACACS+ Authentication

These sections describe how to configure TACACS+ authentication on the switch:
•
•
•
•
•
•
•
•
•
•
Specifying TACACS+ Servers
Specify one or more TACACS+ servers before you enable TACACS+ authentication on the switch. The
first server you specify is the primary server, unless you explicitly make one server the primary using
the primary keyword.
To specify one or more TACACS+ servers, perform this task in privileged mode:
Task
Step 1 Specify the IP address of one or more TACACS+
servers.
Step 2 Verify the TACACS+ configuration.
This example shows how to specify TACACS+ servers and verify the configuration:
Console> (enable) set tacacs server 172.20.52.3
172.20.52.3 added to TACACS server table as primary server.
Console> (enable) set tacacs server 172.20.52.2 primary
172.20.52.2 added to TACACS server table as primary server.
Console> (enable) set tacacs server 172.20.52.10
172.20.52.10 added to TACACS server table as backup server.
Console> (enable)
78-13315-02
Specifying TACACS+ Servers, page 21-17
Enabling TACACS+ Authentication, page 21-18
Specifying the TACACS+ Key, page 21-19
Specifying the TACACS+ Timeout Interval, page 21-19
Specifying the TACACS+ Login Attempts, page 21-20
Enabling TACACS+ Directed Request, page 21-21
Disabling TACACS+ Directed Request, page 21-21
Clearing TACACS+ Servers, page 21-22
Clearing the TACACS+ Key, page 21-22
Disabling TACACS+ Authentication, page 21-23
Command
set tacacs server ip_addr [primary]
show tacacs
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Authentication
21-17