Configuring Gvrp Registration - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 17 Configuring GVRP

Configuring GVRP Registration

These sections describe how to configure GVRP registration modes on switch ports:
•
•
•
Configuring GVRP Normal Registration
Configuring an 802.1Q trunk port in normal registration mode allows dynamic creation (if dynamic
VLAN creation is enabled), registration, and deregistration of VLANs on the trunk port. Normal mode
is the default.
To configure GVRP normal registration on an 802.1Q trunk port, perform this task in privileged mode:
Task
Step 1 Configure normal registration on an 802.1Q trunk
port.
Step 2 Verify the configuration.
This example shows how to configure normal registration on an 802.1Q trunk port:
Console> (enable) set gvrp registration normal 1/1
Registrar Administrative Control set to normal on port 1/1.
Console> (enable)
Configuring GVRP Fixed Registration
Configuring an 802.1Q trunk port in fixed registration mode allows manual creation and registration of
VLANs, prevents VLAN deregistration, and registers all VLANs known on other ports on the trunk port.
To configure GVRP fixed registration on an 802.1Q trunk port, perform this task in privileged mode:
Task
Step 1 Configure fixed registration on an 802.1Q trunk
port.
Step 2 Verify the configuration.
This example shows how to configure fixed registration on an 802.1Q trunk port:
Console> (enable) set gvrp registration fixed 1/1
Registrar Administrative Control set to fixed on port 1/1.
Console> (enable)
78-13315-02
Configuring GVRP Normal Registration, page 17-5
Configuring GVRP Fixed Registration, page 17-5
Configuring GVRP Forbidden Registration, page 17-6
Command
set gvrp registration normal mod/port
show gvrp configuration
Command
set gvrp registration fixed mod/port
show gvrp configuration
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring GVRP
17-5