Configuring Auxiliary Vlans On Catalyst Lan Switches - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 44 Configuring a VoIP Network
PS Configuration : PS1 and PS2 in Redundant Configuration.
Total Power Available: 1153.32 Watts (27.46 Amps @ 42V)
Total Power Available for Line Card Usage: 1153.32 Watts (27.46 Amps @ 42V)
Total Power Drawn From the System: 289.80 Watts (6.90 Amps @ 42V)
Remaining Power in the System: 863.52 Watts (20.56 Amps @42V)
Default inline power allocation: 10.5 Watts/port (0.25 Amps @ 42V)
Slot power Requirement/Usage :
Slot
----
1
2
3
5
6
7
9
Console> (enable)
A partial-deny status indicates that some module ports are inline powered but not all the ports on the
module are inline powered.

Configuring Auxiliary VLANs on Catalyst LAN Switches

These sections describe how to configure auxiliary VLANs:
•
•
•
•
Understanding Auxiliary VLANs
You can configure switch ports to send CDP packets that instruct an attached Cisco IP Phone 7960 to
transmit voice traffic to the switch in these frame types:
•
•
•
Note The Cisco IP Phone 7960 always sets Layer 3 IP precedence to 5 in voice traffic.
78-13315-02
Card-Type
-------------------
WS-X6K-SUP1-2GE
WS-X6348-RJ-45
WS-X6348-RJ-45
Unknown
WS-X6248-RJ-45
WS-X6416-GE-MT
Understanding Auxiliary VLANs, page 44-19
Auxiliary VLAN Configuration Guidelines, page 44-20
Configuring Auxiliary VLANs, page 44-20
Verifying Auxiliary VLAN Configuration, page 44-21
802.1Q frames carrying the auxiliary VLAN ID and Layer 2 CoS set to 5 (the switch port drops all
802.1Q frames except those carrying the auxiliary VLAN ID).
– Reset the Cisco IP Phone 7960 if the auxiliary VLAN ID changes.
– Enter the set port auxiliaryvlan mod[/port] aux_vlan_id command.
We recommend that you use 802.1Q frames and a separate VLAN.
Note
802.1p frames, which are 802.1Q frames carrying VLAN ID 0 and Layer 2 CoS set to 5 (enter the
set port auxiliaryvlan mod[/port] dot1p command)
802.3 frames, which are untagged and carry no VLAN ID and no Layer 2 CoS value (enter the set
port auxiliaryvlan mod[/port] untagged command)
Power-Requested Power-Allocated
Watts A @ 42V Watts
------- ------- ------- -------
0.00 0.00 126.42
138.60 3.30 138.60
114.24 2.72 151.20
109.20 2.60 100.88
112.98 2.69 0
84.84 2.02 0
105.00 2.50 0
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring VoIP on a Switch
Card-Status
A @ 42V
------------
3.01 none
3.30 ok
3.60 ok
2.40 partial-deny
0 unknown
0 power-bad
0 power-deny
44-19