Displaying Qos Information - Cisco 3845 - Security Bundle Router Software Manual

Chapter 27 Configuring QoS
Command
Step 3
service instance number ethernet [name]
Step 4
encapsulation {default | dot1q |
priority-tagged | untagged}
Step 5
bridge-domain bridge-id [split-horizon group
group-id]
Step 6 service-policy {input | output}
policy-map-name
Step 7
end
Step 8
show ethernet service instance policy-map
Step 9
copy running-config startup-config
To remove the policy map and port association, use the no service-policy {input | output}
policy-map-name service-instance configuration command.

Displaying QoS Information

To display QoS information, use one or more of the privileged EXEC commands in
explanations about available keywords, see the command reference for this release.
Table 27-2 Commands for Displaying Standard QoS Information
Command
show class-map [class-map-name]
show policy-map [policy-map-name | interface
[interface-id] [input | output] [class class-name]]
show ethernet service-instance policy map
show running-config
OL-23400-01
Purpose
Configure an EFP (service instance) and enter service-instance
configuration mode. See Chapter 11, "Configuring Ethernet
Virtual Connections (EVCs)."
You must enter the switchport mode trunk and
Note
switchport trunk allowed vlan none interface
configuration commands on an interface before
configuring an EFP. You must also enter the no ip
igmp-snooping vlan vlan-id command for the VLAN of
the bridge domain.
Configure encapsulation type for the service instance.
Note You must configure encapsulation type and a bridge
domain for the service instance, or the service-policy
command will be rejected.
Configure the bridge domain ID. The range is from 1 to 8000.
Specify the policy-map name and whether it is an input policy
map or an output policy map.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Display QoS class-map information for all class maps or the
specified class map.
Display QoS policy map information for the specified policy
map name, interface, input or output policy maps, or policy-map
class.
Display QoS policy map information for policy maps attached to
EFP service instances.
Display the configured class maps, policy maps, table maps, and
aggregate policers.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Displaying QoS Information
Table 27-2. For
27-57