Configuring Multicast Router Ports And Group Entries; Specifying Multicast Router Ports - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring Multicast Router Ports and Group Entries

This example shows how to disable GMRP globally on the switch:
Console> (enable) set gmrp disable
GMRP disabled.
Console> (enable)
Configuring Multicast Router Ports and Group Entries
These sections describe how to specify multicast router ports manually and configure multicast group
entries:
•
•
•
•

Specifying Multicast Router Ports

When you enable IGMP snooping, the switch automatically learns to which ports a multicast router is
connected. However, if desired, you can manually specify multicast router ports.
To specify multicast router ports manually, perform this task in privileged mode:
Task
Step 1
Manually specify a multicast router port.
Step 2 Verify the configuration.
This example shows how to specify a multicast router port manually and verify the configuration (the
asterisk [*] next to the multicast router on port 3/1 indicates that the entry was configured manually):
Console> (enable) set multicast router 3/1
Port 3/1 added to multicast router port list.
Console> (enable) show multicast router
IGMP disabled
Port
---------
2/1
2/2
3/1
7/9
Total Number of Entries = 4
'*' - Configured
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
40-20
Specifying Multicast Router Ports, page 40-20
Configuring Multicast Groups, page 40-21
Clearing Multicast Router Ports, page 40-21
Clearing Multicast Group Entries, page 40-22
Vlan
----------------
99
255
* 1
2,99
Chapter 40 Configuring Multicast Services
Command
set multicast router mod/port
show multicast router [mod/port] [vlan_id]
78-13315-02