Clearing The Nde Flow Filter; Disabling Nde; Removing The Nde Ip Address - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 15 Configuring NDE
This example shows how to remove a protocol for statistics collection:
Console> (enable) clear mls statistics protocol 17 1934
Protocol 17 port 1934 cleared from protocol statistics list.
Console> (enable)

Clearing the NDE Flow Filter

To clear the NDE flow filter and reset the filter to the default (all flows exported), perform this task in
privileged mode:
Task
Clear the NDE flow filter.
This example shows how to clear the NDE flow filter so that all flows are exported:
Console> (enable) clear mls nde flow
Netflow data export filter cleared.
Console> (enable)

Disabling NDE

With Supervisor Engine 1 and a PFC, if NDE is enabled and you disable MLS, you lose the statistics
Note
for existing cache entries—they are not exported.
To disable NDE on the switch, perform this task in privileged mode:
Task
Disable NDE on the switch.
This example shows how to disable NDE on the switch:
Console> (enable) set mls nde disable
Netflow data export disabled.
Console> (enable)

Removing the NDE IP Address

To remove the NDE IP address from the MSFC, perform this task in global configuration mode:
Task
Remove the NDE IP address from the
MSFC.
78-13315-02
Command
clear mls nde flow
Command
set mls nde disable
Command
Router(config)# no mls nde-address [ip_addr]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring NDE
15-9