Configuring Appletalk Intervlan Routing On The Msfc; Configuring Msfc Features - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring InterVLAN Routing on the MSFC
This example shows how to enable IPX routing on the MSFC, create a VLAN interface, and assign the
interface an IPX network address:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ipx routing
Router(config)# ipx router rip
Router(config-ipx-router)# network all
Router(config-ipx-router)# interface vlan100
Router(config-if)# ipx network 100 encapsulation snap
Router(config-if)# ^Z
Router#

Configuring AppleTalk InterVLAN Routing on the MSFC

To configure interVLAN routing for AppleTalk, perform this task:
Task
Step 1 (Optional) Enable AppleTalk routing on
the router
Step 2 Specify a VLAN interface on the MSFC. Router(config)# interface vlan-id
Step 3
Assign a cable range to the VLAN.
Step 4
Assign a zone name to the VLAN.
Step 5 Exit configuration mode.
1.
This example shows how to enable AppleTalk routing on the MSFC, create a VLAN interface, and
assign the interface an AppleTalk cable-range and zone name:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# appletalk routing
Router(config)# interface vlan100
Router(config-if)# appletalk cable-range 100-100
Router(config-if)# appletalk zone Engineering
Router(config-if)# ^Z
Router#

Configuring MSFC Features

These sections describe features implemented on the MSFC:
•
•
•
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
12-4
1
.
This step is necessary if you have multiple routers in the network.
Local Proxy ARP, page 12-5
WCCP Layer 2 Redirection, page 12-5
Auto State Feature, page 12-5
Chapter 12
End with CNTL/Z.
Command
Router(config)# appletalk routing
Router(config-if)# appletalk cable-range cable-range
Router(config-if)# appletalk zone zone-name
Router(config-if)# Ctrl-Z
End with CNTL/Z.
Configuring InterVLAN Routing
78-13315-02