Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 437

Catalyst 6000 series software configuration guide
Hide thumbs Also See for WS-X6066-SLB-APC - Content Switching Module:
Table of Contents

Advertisement

Chapter 21
Configuring Switch Access Using AAA
Specifying the RADIUS Timeout Interval
You can specify the timeout interval between retransmissions to the RADIUS server. The default timeout
is 5 seconds.
To specify the RADIUS timeout interval, perform this task in privileged mode:
Task
Step 1
Specify the RADIUS timeout interval.
Step 2
Verify the RADIUS configuration.
This example shows how to specify the RADIUS timeout interval and verify the configuration:
Console> (enable) set radius timeout 10
Radius timeout set to 10 seconds.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Specifying the RADIUS Retransmit Count
You can specify the number of times the switch will attempt to contact a RADIUS server before the next
configured server is tried. By default, each RADIUS server will be tried two times.
To specify the RADIUS retransmit count, perform this task in privileged mode:
Task
Step 1
Specify the RADIUS server retransmit count.
Step 2
Verify the RADIUS configuration.
This example shows how to specify the RADIUS retransmit count and verify the configuration:
Console> (enable) set radius retransmit 4
Radius retransmit count set to 4.
Console> (enable) show radius
78-13315-02
Command
set radius timeout seconds
show radius
Console Session
Telnet Session
----------------
----------------
disabled
disabled
enabled(primary)
enabled(primary)
enabled
enabled
Telnet Session
disabled
disabled
enabled(primary)
enabled(primary)
enabled
enabled
0 minutes
Secret_RADIUS_key
2
10 seconds
Status
Auth-port
------------
primary
1812
Command
set radius retransmit count
show radius
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Authentication
21-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents