Configuring Policy-Based Forwarding; Enabling Pbf And Specifying A Mac Address For The Pfc2 - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring Policy-Based Forwarding

Configuring Policy-Based Forwarding
This section provides guidelines and configuration examples for PBF. The configuration examples use
the example configuration shown in
coming from Host A on VLAN 10 to Host B on VLAN 11, and redirects traffic from Host B to Host A.
This section contains the following example procedures:
•
•
•
•
•
•
Figure 16-8 Policy-Based Forwarding
Host A
IP 10.0.0.1
MAC 00:00:00:00:00:0A
Interface: Ethernet1

Enabling PBF and Specifying a MAC Address for the PFC2

The MAC address can be a default or user-specified MAC address. The default MAC address is taken
Note
from a MAC address PROM on the Catalyst 6000 family switch chassis. When specifying a MAC
address using the set pbf mac command, ensure that the MAC address is unique and not already
being used on any interfaces.
We recommend that you use the default MAC address provided by the MAC address PROM. When
you specify your own MAC address using the set pbf mac command, if the MAC address is a
duplicate of a MAC address already in use, packets might get dropped.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
16-48
Enabling PBF and Specifying a MAC Address for the PFC2, page 16-48
Configuring VACLs for PBF, page 16-50
Displaying PBF Information, page 16-52
Clearing Entries in PBF VACLs, page 16-52
Rolling Back Adjacency Table Entries in the Edit Buffer, page 16-53
Configuring Hosts for PBF, page 16-53
Catalyst 6500 series switches
VLAN 10
Figure 16-8. The Catalyst 6000 family switch redirects all the traffic
PFC2 MAC address:
00-11-11-11-11-11
Chapter 16 Configuring Access Control
VLAN 11
Host B
IP 11.0.0.1
MAC 00:00:00:00:00:0B
Interface: Ethernet0
78-13315-02