Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 751

Chapter 41 Configuring QoS
This example shows how to revert to the default values for the default IP ACL:
Console> (enable) clear qos acl default-action ip
Hardware programming in progress...
QoS default-action for IP ACL is restored to default setting.
Console> (enable)
Discarding Uncommitted ACLs
To discard an uncommitted new ACL or uncommitted changes to an existing ACL, perform this task in
privileged mode:
Task
Step 1
Discard an uncommitted ACL.
Step 2 If you discarded changes to an existing ACL,
verify the configuration.
This example shows how to discard an uncommitted ACL named my_acl:
Console> (enable) rollback qos acl my_acl
Rollback for QoS ACL my_acl is successful.
Console> (enable)
Changes to the default ACLs take effect immediately and cannot be discarded.
Note
Committing ACLs
When you create, change, or delete a named ACL, the changes exist temporarily in an edit buffer in
memory. To commit the ACL so that it can be used, perform this task in privileged mode:
Task
Step 1 Commit an ACL.
Step 2 Verify the configuration.
This example shows how to commit an ACL named my_acl:
Console> (enable) commit qos acl my_acl
Hardware programming in progress...
ACL my_acl is committed to hardware.
Console> (enable)
When you commit an ACL that has already been attached to interfaces, the new values go into effect
Note
immediately. Changes to the default ACLs do not need to be committed.
See
information about where QoS ACLs are stored.
78-13315-02
"Configuring and Storing VACLs and QoS ACLs in Flash Memory" section on page 16-42
Command
rollback qos acl {acl_name | all}
show qos acl info {acl_name | all}
Command
commit qos acl acl_name
show config qos acl {acl_name | all}
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring QoS
for
41-45