Setting The Port Configuration; Setting The Port Name - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Setting the Port Configuration

Setting the Port Configuration
These sections describe how to configure Ethernet, Fast Ethernet, and Gigabit Ethernet switching on the
Catalyst 6000 family switches:
•
•
•
•
•
•
•
•
•
•

Setting the Port Name

You can set port names on Ethernet, Fast Ethernet, and Gigabit Ethernet switching modules to facilitate
switch administration.
To set the port name, perform this task in privileged mode:
Task
Step 1 Set a port name.
Step 2 Verify the port name is configured.
This example shows how to set the name for ports 1/1 and 1/2 and how to verify that the port names are
configured correctly:
Console> (enable) set port name 1/1 Router Connection
Port 1/1 name set.
Console> (enable) set port name 1/2 Server Link
Port 1/2 name set.
Console> (enable) show port 1
Port
----- ------------------ ---------- ----------
1/1
1/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Wed Jun 16 1999, 16:25:57
Console> (enable)
Catalyst 6000 Family Software Configuration Guide-Releases 6.3 and 6.4
4-4
Setting the Port Name, page 4-4
Setting the Port Speed, page 4-5
Setting the Port Duplex Mode, page 4-5
Configuring IEEE 802.3X Flow Control, page 4-6
Enabling and Disabling Port Negotiation, page 4-7
Changing the Default Port Enable State, page 4-7
Setting the Port Debounce Timer, page 4-8
Configuring a Timeout Period for Ports in errdisable State, page 4-9
Configuring the Jumbo Frame Feature, page 4-11
Checking Connectivity, page 4-13
Name Status
Router Connection connected
Server Link connected
Chapter 4 Configuring Ethernet, Fast Ethernet, and Gigabit Ethernet Switching
Command
set port name mod/port [name_string]
show port [mod[/port]]
Vlan Duplex Speed Type
------ ----- ------------
trunk full
trunk full
1000 1000BaseSX
1000 1000BaseSX
78-13315-02