Configuring Per-Port Power Management - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring VoIP on a Switch
Table 44-3 Voice-Related CLI Command Module and Platform Support (continued)
CLI Commands
Voice-related commands
set port auxiliaryvlan
show port auxiliaryvlan
set port voice interface
show port voice interface
show port voice
show port voice fdl
show port voice active
QoS commands related to voice
set port qos mod/port cos-ext
set port qos mod/port trust-ext
show port qos
1. WS-X6348-RJ45V = 48-port 10/100BASE-TX switching module with voice daughter card.
2. WS-X6608-T1 and WS-X6608-E1 = 8-port T1/E1 ISDN PRI modules.
3. WS-X6624-FXS = 24-port FXS analog station interface module.
4. X = Command supported on Catalyst 6000 family switch only; XX = Command supported on Catalyst 4000, 5000, and 6000 family switches (note that
all modules listed in Table 44-3

Configuring Per-Port Power Management

This section describes per-port power management and the CLI commands used to configure power
management for IP phones.
Note To determine the exact power requirements for your configuration to ensure that you are within the
system power budget, see the
Note This section applies to the WS-X6348-RJ45V 10/100BASE-TX Ethernet switching module only. For
information on powering IP phones connected to other Catalyst 10/100BASE-TX switching
modules, refer to the Catalyst Family Inline-Power Patch Panel Installation Note publication.
For each IP phone connected to the WS-X6348-RJ45V module, the supervisor engine software allocates
part of the available system power to power up and run the phone. The power can be applied on an
individual port basis.
Only one IP phone can be powered per port; the phone must be connected directly to the switch port. If
a second phone is daisy chained off the phone connected to the switch port, the second phone cannot be
powered by the switch.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
44-10
are supported only on Catalyst 6000 family switches).
"Determining System Power Requirements" section on page
1
WS-X6348-RJ45V WS-X6608-T1/E1
X/X
X/X
X
X
X X
X
X X
X/X
X/X
Chapter 44 Configuring a VoIP Network
2
WS-X6624-FXS
X
X
X
X
20-14.
78-13315-02
3