Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 763

Chapter 41 Configuring QoS
Enter up to 64 internal DSCP value list/egress CoS value pairs. This example shows how to map internal
DSCP values to egress CoS values:
Console> (enable) set qos dscp-cos-map 20-25:7 33-38:3
QoS dscp-cos-map set successfully.
Console> (enable)
To revert to default CoS to DSCP value mapping, perform this task in privileged mode:
Task
Step 1 Revert to DSCP value/CoS value map defaults.
Step 2
Verify the configuration.
This example shows how to revert to CoS-DSCP map defaults:
Console> (enable) clear qos dscp-cos-map
QoS dscp-cos-map setting restored to default.
Console> (enable)
Mapping DSCP Markdown Values
To map DSCP markdown values used by policing rules, perform this task in privileged mode:
Task
Step 1 Map DSCP values to markdown DSCP values.
Step 2 With PFC2, map DSCP values to markdown
DSCP values.
Step 3 Verify the configuration.
For more information, see the
Enter up to 64 DSCP-value-list/DSCP-value pairs.
This example shows how to map DSCP markdown values:
Console> (enable) set qos policed-dscp-map 20-25:7 33-38:3
QoS dscp-dscp-map set successfully.
Console> (enable)
This example shows how to map DSCP markdown values for packets exceeding the excess rate:
Console> (enable) set qos policed-dscp-map 33:30
QoS normal-rate policed-dscp-map set successfully.
Console> (enable) set qos policed-dscp-map excess-rate 33:30
QoS excess-rate policed-dscp-map set successfully.
Console> (enable)
78-13315-02
Command
clear qos dscp-cos-map
show qos maps {config | runtime}
[cos-dscp-map | ipprec-dscp-map |
dscp-cos-map | policed-dscp-map]
Command
set qos policed-dscp-map
dscp_list:markdown_dscp ...
set qos policed-dscp-map [normal | excess]
in_profile_dscp_list:policed_dscp ...
show qos maps {config | runtime}
[cos-dscp-map | ipprec-dscp-map |
dscp-cos-map | policed-dscp-map]
"Policing Rules" section on page
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring QoS
41-22.
41-57