Specifying Radius Servers - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Understanding How Accounting Works

Specifying RADIUS Servers

To specify one or more RADIUS servers, perform this task in privileged mode:
Task
Step 1 Specify the IP address of up to three RADIUS
servers. Specify the primary server using the
primary keyword. Optionally, specify the
destination UDP port to use on the server.
Step 2
Verify the RADIUS server configuration.
This example shows how to specify a RADIUS server and verify the configuration:
Console> (enable) set radius server 172.20.52.3
172.20.52.3 with auth-port 1812 added to radius server table as primary server.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
21-58
Stop records include complete information of the event (when the event started, its
Note
duration, and traffic statistics). However, you might want redundancy and, therefore,
may monitor both start and stop records of events occurring on the NAS.
Console Session
----------------
disabled
disabled
enabled(primary)
disabled
disabled
enabled(primary)
Chapter 21
Command
set radius server ip_addr [acct-port port]
[primary]
show radius
Telnet Session
----------------
disabled
disabled
enabled(primary)
Telnet Session
disabled
disabled
enabled(primary)
0 minutes
2
5 seconds
Status Auth-port
------------
primary 1812
Configuring Switch Access Using AAA
78-13315-02