Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 56

Configuring the SLIP (sl0) Interface on the Console Port
To disable SLIP on the console port, perform this task:
Task
Step 1
Access the switch from a remote host with Telnet. telnet {host_name | ip_addr}
Step 2
Enter privileged mode on the switch.
Step 3 Disable SLIP for the console port.
This example shows how to configure SLIP on the console port and verify the configuration:
sparc20% telnet 172.20.52.38
Trying 172.20.52.38 ...
Connected to 172.20.52.38.
Escape character is '^]'.
Cisco Systems, Inc. Console
Enter password:
Console> enable
Enter password:
Console> (enable) set interface sl0 10.1.1.1 10.1.1.2
Interface sl0 slip and destination address set.
Console> (enable) show interface
sl0: flags=51<UP,POINTOPOINT,RUNNING>
sc0: flags=63<UP,BROADCAST,RUNNING>
Console> (enable) slip attach
Console Port now running SLIP.
Console> (enable) slip detach
SLIP detached on Console port.
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
3-8
slip 10.1.1.1 dest 10.1.1.2
vlan 522 inet 172.20.52.38 netmask 255.255.255.240 broadcast 172.20.52.7
Chapter 3 Configuring the Switch IP Address and Default Gateway
Command
enable
slip detach
78-13315-02