Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 263

Chapter 14 Configuring MLS
This example shows how to disable IP MLS on an MSFC interface:
Router(config)# interface vlan 100
Router(config-if)# no mls ip
Router(config-if)#
This example shows how to disable IPX MLS on an MSFC interface:
Router(config)# interface vlan 100
Router(config-if)# no mls ipx
Router(config-if)#
Unicast MLS is enabled by default; you only need to enable (or reenable) it if you have previously
Note
disabled it.
To enable unicast IP or IPX MLS on a specific MSFC interface, perform this task:
Task
Specify an MSFC interface.
Enable IP MLS on an MSFC interface. Router(config-if)# mls ip
Enable IPX MLS on an MSFC
interface.
This example shows how to enable IP MLS on an MSFC interface:
Router(config)# interface vlan 100
Router(config-if)# mls ip
Router(config-if)#
This example shows how to enable IPX MLS on an MSFC interface:
Router(config)# interface vlan 100
Router(config-if)# mls ipx
Router(config-if)#
Displaying MLS Information on the MSFC
The show mls status command displays MLS details.
To display MLS information on the MSFC, perform this task:
Task
Display MLS status.
This example shows how to display MLS status on the MSFC:
Router# show mls status
MLS global configuration status:
global mls ip:
global mls ipx:
global mls ip multicast:
current ip flowmask for unicast:
current ipx flowmask for unicast:
Router#
78-13315-02
Command
Router(config)# interface vlan-id
Router(config-if)# mls ipx
Command
show mls status
enabled
enabled
disabled
destination only
destination only
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring MLS
14-15