Specifying An Nde Destination Address On The Msfc; Specifying An Nde Source Address On The Msfc - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Catalyst 6000 series software configuration guide
Hide thumbs Also See for WS-X6066-SLB-APC - Content Switching Module:
Table of Contents

Advertisement

Chapter 15
Configuring NDE
This example shows how to specify an NDE collector:
Console> (enable) set mls nde Stargate 9996
Netflow data export not enabled.
Netflow data export to port 9996 on 172.20.15.1(Stargate)
Console> (enable)

Specifying an NDE Destination Address on the MSFC

To monitor data and statistics about Layer 3 traffic that is switched in software by the MSFC, you must
specify the NDE collector and UDP port on the MSFC by entering the ip flow-export destination
command on the MSFC.
To specify the NDE collector for Layer 3 traffic that is being switched by the MSFC, peform this task
in privileged mode:
Task
Specify an NDE collector and UDP port for
data export of software-switched packets.
This example shows how to specify the NDE collector from the MSFC:
Router(config)# ip flow-export destination Stargate 9996
Router(config)#

Specifying an NDE Source Address on the MSFC

The MSFC and the PFC use the NDE source address when sending statistics to the data collection
application. You configure the source address on the MSFC so the data collection application can
aggregate export data from both the MSFC and the PFC for the same flow by entering the ip flow-export
source vlan command on the MSFC.
The ip flow-export source vlan command is optional. If you do not specify an NDE source address
Note
on the MSFC, the MSFC and PFC automatically use the IP address of one of the MSFC VLAN
interfaces.
To specify the NDE source address for Layer 3 traffic that is being switched by the MSFC, peform this
task in privileged mode:
Task
Specify an NDE source address for data
export of software-switched packets.
This example shows how to specify the NDE source address on the MSFC:
Router(config)# ip flow-export source vlan 10
Router(config)#
78-13315-02
Command
ip flow-export destination {hostname | ip_address}
{udp_port_number}
Command
ip flow-export source vlan {vlan_interface_number}
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring NDE
15-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents