Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 68

Setting the Port Configuration
A port enters errdisable state for the following reasons (these reasons appear as configuration options
with the set errdisable-timeout enable command):
• Channel misconfiguration
Duplex mismatch
•
BPDU port-guard
•
UDLD
•
Other (reasons other than the above)
•
All (apply errdisable timeout to all reasons)
•
You can enable or disable errdisable timeout for each of the above listed reasons. The ports in errdisable
state for reasons other than the first four reasons are considered "other." If you specify "other," all ports
errdisabled by causes other than the first four reasons are enabled for errdisable timeout. If you specify
"all," all ports errdisabled for any reason are enabled for errdisable timeout.
The errdisable feature is disabled by default. The default interval for enabling a port is 300 seconds. The
allowable interval range is 30 to 86400 seconds (30 seconds to 24 hours).
This example shows how to enable errdisable timeout for BPDU guard causes:
Console> (enable) set errdisable-timeout enable bpdu-guard
Successfully enabled errdisable-timeout for bpdu-guard.
Console> (enable)
This example shows how to enable errdisable timeout for all causes:
Console> (enable) set errdisable-timeout enable all
Successfully enabled errdisable-timeout for all.
Console> (enable)
This example shows how to set the errdisable timeout interval to 450 seconds:
Console> (enable) set errdisable-timeout interval 450
Successfully set errdisable timeout to 450 seconds.
Console> (enable)
This example shows how to display the errdisable timeout configuration:
Console> (enable) show errdisable-timeout
ErrDisable Reason
------------------- ------------
bpdu-guard
channel-misconfig
duplex-mismatch
udld
other
Interval: 300 seconds
Ports that will be enabled at the next timeout:
Port
----- -----------------
3/1
3/8
6/5
7/24 duplex-mismatch
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
4-10
Timeout Status
Enable
Disable
Enable
Enable
Disable
ErrDisable Reason
udld
bpdu-guard
udld
Chapter 4 Configuring Ethernet, Fast Ethernet, and Gigabit Ethernet Switching
78-13315-02