Clearing Multicast Group Entries; Configuring Rgmp; Configuring Rgmp On The Supervisor Engine - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring RGMP

Clearing Multicast Group Entries

To clear manually configured multicast group entries, perform this task in privileged mode:
Task
Clear a multicast group entry from the CAM
table.
This example shows how to clear a multicast group entry from the CAM table:
Console> (enable) clear cam 01-11-22-33-44-55 1
CAM entry cleared.
Console> (enable)
Configuring RGMP
These sections describe the commands for configuring RGMP:
•
•

Configuring RGMP on the Supervisor Engine

These sections describe the commands for configuring RGMP:
•
•
•
•
•
•
•
Default RGMP Configuration
RGMP is disabled by default.
Enabling and Disabling RGMP
To enable RGMP, you must have IGMP snooping enabled.
Note
To enable or disable RGMP, perform these tasks in privileged mode:
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
40-22
Configuring RGMP on the Supervisor Engine, page 40-22
Configuring RGMP on the MSFC, page 40-25
Default RGMP Configuration, page 40-22
Enabling and Disabling RGMP, page 40-22
Displaying RGMP Group Information, page 40-23
Displaying RGMP VLAN Statistics, page 40-23
Displaying Ports Connected to RGMP-Capable Routers, page 40-24
Clearing RGMP Statistics, page 40-25
RGMP-Related CLI Commands, page 40-25
Chapter 40 Configuring Multicast Services
Command
clear cam mac_addr [vlan]
78-13315-02