Using Ciscoworks2000 - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Understanding How SNMPv1 and SNMPv2c Works
•
Note
•
•
Note

Using CiscoWorks2000

CiscoWorks2000 is a family of Web-based and management platform-independent products for
managing Cisco enterprise networks and devices. CiscoWorks2000 includes Resource Manager
Essentials and CWSI Campus, which allow you to deploy, configure, monitor, manage, and troubleshoot
a switched internetwork. For more information, refer to the following publications:
•
•
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
36-6
Setting a MIB variable—This function is also initiated by the SNMP agent in response to a message
from the NMS. The SNMP agent changes the value of the MIB variable to the value requested by
the NMS.
For more information about MIBs, refer to
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
SNMP trap—This function is used to notify an NMS that a significant event has occurred at an
agent. When a trap condition occurs, the SNMP agent sends an SNMP trap message to any NMSs
specified as the trap receivers, under the following conditions:
When a port or module goes up or down
–
When temperature limitations are exceeded
–
When there are spanning tree topology changes
–
When there are authentication failures
–
When power supply errors occur
–
SNMP community strings—SNMP community strings authenticate access to MIB objects and
function as embedded passwords:
Read-only—Gives read access to all objects in the MIB except the community strings, but does
–
not allow write access
Read-write—Gives read and write access to all objects in the MIB, but does not allow access to
–
the community strings
Read-write-all—Gives read and write access to all objects in the MIB, including the community
–
strings
The community string definitions on your NMS must match at least one of the three
community string definitions on the switch.
Getting Started With Resource Manager Essentials
Getting Started With CWSI Campus
Chapter 36 Configuring SNMP
78-13315-02