Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 512

MSFC Redundancy
hostname Router1 alt hostname Router2
!
boot bootldr bootflash:c6msfc-boot-mz.120-7.XE1
!
ip subnet-zero
!
ip cef
redundancy
high-availability
config-sync
cns event-service server
!
!
!
interface Vlan1
ip address 70.0.70.4 255.255.0.0 alt ip address 70.0.70.5 255.255.0.0
!
interface Vlan10
ip address 192.10.10.1 255.255.255.0 alt ip address 192.10.10.2 255.255.255.0
no ip redirects
shutdown
standby ip 192.20.20.1 alt standby ip 192.20.20.1
!
ip classless
ip route 223.255.254.0 255.255.255.0 70.0.100.0
no ip http server
!
!
!
line con 0
transport input none
line vty 0 4
login
transport input lat pad mop telnet rlogin udptn nasi
!
end
Scenario 2: Disabling Configuration Synchronization on the Designated MSFC
In this scenario, configuration synchronization is enabled. These examples show how to disable
configuration synchronization:
Router-16# configure terminal
Enter configuration commands, one per line.
Router2(config)# redundancy
Router2(config-r)# high-availability
Router2(config-r-ha)# no config-sync
When configuration synchronization is disabled, the following message is displayed on the
nondesignated MSFC:
00:13:00: %RUNCFGSYNC-6-SYNCEVENT:
The High-Availability Redundancy Feature is now disabled
The config mode is now accessible
Configuration mode is available on the CLI of the designated and nondesignated MSFC.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
22-38
Chapter 22
End with CNTL/Z.
Configuring Redundancy
78-13315-02