Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 768

Configuring QoS
This example shows how to select COPS as the QoS policy source:
Console> (enable) set qos policy-source cops
QoS policy source for the switch set to COPS.
Console> (enable) show qos policy-source
QoS policy source for the switch set to COPS.
Console> (enable)
Selecting COPS as the QoS policy source switches the following values from locally configured values
to received COPS values:
•
•
•
•
•
•
•
Selecting Locally Configured QoS Policy
To select locally configured QoS policy, perform this task in privileged mode:
Task
Step 1 Select locally configured QoS policy.
Step 2 Verify the QoS policy source.
This example shows how to select locally configured QoS policy:
Console> (enable) set qos policy-source local
QoS policy source for the switch set to local.
Console> (enable) show qos policy-source
QoS policy source for the switch set to local.
Console> (enable)
Enabling Use of Locally Configured QoS Policy
When enabled, COPS is the default QoS policy source for all ports. You can use locally configured QoS
policy on a per-ASIC basis. To enable use of locally configured QoS policy on a port ASIC, perform this
task in privileged mode:
Task
Step 1
Enable use of locally configured QoS policy on a
port.
Step 2
Verify the QoS policy source for the port.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
41-62
All DSCP maps
Named and default ACL definitions
Microflow and aggregate policing rules
CoS to queue assignments
Threshold configuration
WRR weight and buffer configuration
Default port CoS and ACL-to-interface attachments
Chapter 41
Command
set qos policy-source {local | cops}
show qos policy-source
Command
set port qos policy-source {local | cops}
show port qos
Configuring QoS
78-13315-02