Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 435

Chapter 21 Configuring Switch Access Using AAA
To specify the RADIUS key, perform this task in privileged mode:
Task
Step 1
Specify the RADIUS key used to encrypt packets
sent to the RADIUS server.
Step 2
Verify the RADIUS configuration.
This example shows how to specify the RADIUS key and verify the configuration (in normal mode, the
RADIUS key value is hidden):
Console> (enable) set radius key Secret_RADIUS_key
Radius key set to Secret_RADIUS_key
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Enabling RADIUS Authentication
Specify at least one RADIUS server before enabling RADIUS authentication on the switch. For
Note
information on specifying a RADIUS server, see the
page
You can enable RADIUS authentication for login and enable access to the switch. If desired, you can
enter the console or telnet keyword to specify that RADIUS authentication be used only on console or
Telnet connections. If you are using both RADIUS and TACACS+, you can use the primary keyword
to force the switch to try RADIUS authentication first.
78-13315-02
Console Session
----------------
disabled
enabled(primary)
enabled
disabled
enabled(primary)
enabled
21-24.
Command
set radius key key
show radius
Telnet Session
----------------
disabled
enabled(primary)
enabled
Telnet Session
disabled
enabled(primary)
enabled
0 minutes
Secret_RADIUS_key
2
5 seconds
Status Auth-port
------------
primary 1812
"Specifying RADIUS Servers" section on
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Authentication
21-25