Checking Port Capabilities; Using Telnet - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Checking Port Capabilities

Port
----- ---------- --------- ----- ----- ----------------------------------- -----
1/1
Port
----- ---------- ---------- ---------- ---------- ---------
1/1
Port
----- ---------- ---------- ---------- ---------- --------- --------- ---------
1/1
Last-Time-Cleared
--------------------------
Tue Jun 8 1999, 10:01:35
Console> (enable)
Checking Port Capabilities
You can display the capabilities of any port in a switch using the show port capabilities [[mod][/port]]
command.
This example shows you how to display the port capabilities for switch ports:
Console> (enable) show port capabilities 1/1
Model
Port
Type
Speed
Duplex
Trunk encap type
Trunk mode
Channel
Broadcast suppression
Flow control
Security
Membership
Fast start
QOS scheduling
CoS rewrite
ToS rewrite
UDLD
Inline power
AuxiliaryVlan
SPAN
COPS port group
Console> (enable)

Using Telnet

You can access the switch command-line interface (CLI) using Telnet. In addition, you can use Telnet
from the switch to access other devices in the network. Up to eight simultaneous Telnet sessions are
possible.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
19-4
Status Channel Admin Ch
Mode Group Id
connected auto 65
Align-Err FCS-Err Xmit-Err
0 0
Single-Col Multi-Coll Late-Coll
0 0
WS-X6K-SUP1A-2GE
1/1
No Connector
1000
full
802.1Q,ISL
on,off,desirable,auto,nonegotiate
yes
percentage(0-100)
receive-(off,on,desired),send-(off,on,desired)
yes
static,dynamic
yes
rx-(1p1q4t),tx-(1p2q2t)
yes
DSCP
yes
no
no
source,destination
1/1-2
Chapter 19
Neighbor
Device
0
Rcv-Err UnderSize
0 0
Excess-Col Carri-Sen Runts
0 0
Checking Port Status and Connectivity
Neighbor
Port
0
Giants
0 0 0
78-13315-02