3Com MSR 50 Series Configuration Manual page 1298

1298 C 75: M
HAPTER ULTICAST
VPN C
ONFIGURATION
[PE1] interface ethernet 0/3
[PE1-Ethernet0/3] ip binding vpn-instance a
[PE1-Ethernet0/3] ip address 10.110.2.1 24
[PE1-Ethernet0/3] pim sm
[PE1-Ethernet0/3] quit
# Configure an IP address for Loopback 1.
[PE1] interface loopback 1
[PE1-LoopBack1] ip address 1.1.1.1 32
[PE1-LoopBack1] quit
The interface MTI 0 will automatically obtain an IP address after BGP peer
configuration on PE 1. This address is the loopback interface address specified in
the BGP peer configuration. The PIM mode running on MTI 0 is the same as the
PIM mode running on all the interfaces in VPN instance a.
# Configure BGP.
[PE1] bgp 100
[PE1-bgp] group vpn-g internal
[PE1-bgp] peer vpn-g connect-interface loopback 1
[PE1-bgp] peer 1.1.1.2 group vpn-g
[PE1-bgp] peer 1.1.1.3 group vpn-g
[PE1-bgp] ipv4-family vpn-instance a
[PE1-bgp-a] import-route rip 2
[PE1-bgp-a] import-route direct
[PE1-bgp-a] quit
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer vpn-g enable
[PE1-bgp-af-vpnv4] peer 1.1.1.2 group vpn-g
[PE1-bgp-af-vpnv4] peer 1.1.1.3 group vpn-g
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure OSPF.
[PE1] ospf 1
[PE1-ospf-1] area 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.255.255
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure RIP.
[PE1] rip 2 vpn-instance a
[PE1-rip-2] network 10.0.0.0
[PE1-rip-2] import-route bgp
[PE1-rip-2] return
2 Configure PE 2
# Configure a Router ID, enable IP multicast routing in the public instance,
configure an MPLS LSR ID, and enable the LDP capability.
<PE2> system-view
[PE2] router id 1.1.1.2