Warnings And Cautions - Planmeca ProMax 3D Max with ProTouch Technical Manual

1 General and technical data

1.2 Warnings and cautions

2 Planmeca ProMax 3D Max
WARNING
THE FOLLOWING WARNINGS, CAUTIONS AND NOTES MUST ALWAYS
BE CONSIDERED WHILE SERVICING THE UNIT, IN ORDER TO AVOID
EITHER PERSONAL INJURY OR DAMAGE TO THE UNIT.
WARNING
RADIATION SAFETY RULES
Some procedures described in this manual produce X-ray radiation. Always
follow the rules for radiation protection.
Never attempt to open the TUBE HEAD. It does not contain any serviceable
parts, and radiation safety can no longer be guaranteed.
Never make any exposures without the filter or the beam limiting device
(collimator) in place. Otherwise the radiation safety cannot be guaranteed.
WARNING
ELECTRICAL SAFETY RULES
The unit contains hazardous voltages. While servicing internal parts, the
power supply must be disconnected externally from, for example, a fuse or a
mains switch. The fuse or main switch must be lockable into off-position.
Turning off the unit from its own mains switch DOES NOT cut off the mains
voltage from all internal nodes.
Wait for 2 minutes before touching any electrical parts.
CAUTION
EMC requirements have to be considered, and the equipment must be
installed and put into service according to the specific EMC information
provided in section "EMC information" on page 29.
CAUTION
Portable and mobile RF communications equipment can affect the X-ray
unit. For minimum distance between portable and mobile RF
communications equipment and the X-ray unit, see section "EMC
information" on page 29.
CAUTION
ELECTRICAL SAFETY RULES
Always replace the fuses with ones of the same type and rating. Otherwise
patient, operator or equipment safety cannot be guaranteed.
The circuit boards can be damaged due to static discharges and requires
careful handling.
Technical manual