Calibrating Windrower Knife Drive On The Harvest Performance Tracker Display - MacDon R216 Unloading And Assembly Instructions

4. Press soft key 3 (A) to restore the header float.
NOTE:
If the header float is active, the icon at soft key 3 will
display REMOVE FLOAT; if header float has been removed,
the icon will display RESUME FLOAT.
5. Stop the engine and remove the key.

7.1.5 Calibrating Windrower Knife Drive on the Harvest Performance Tracker Display

When the R216 Rotary Disc Header is attached to an M1240 Windrower, the Harvest Performance Tracker (HPT) will
recognize the header ID and configure the windrower accordingly. The rotary disc header must be calibrated to ensure that
the knife drive pump output is accurate.
CAUTION
Before starting the machine, check to be sure all bystanders have cleared the area.
1. Start the engine.
2. Engage the header.
3. Press soft key 5 (A) to open the Harvest Performance
Tracker (HPT) main menu.
4. Use HPT scroll knob (B) or the ground speed lever (GSL)
scroll wheel to scroll to settings icon (C).
5. Press HPT scroll knob (B) or the GSL SELECT button (not
shown) to activate the settings menu options.
215405
ATTACHING ROTARY DISC HEADER TO WINDROWER
61
Figure 7.38: HPT Display
Figure 7.39: Opening the Main Menu
Revision A