Ppp Paths - Bay Networks NauticaRS Reference Manual

PPP Paths

117237-E Rev.00
Point to Point Protocol (PPP) paths are created using the
following syntax:
[co] [new] pa ppp/pathname
where co takes the router into config mode (if required), new is
the new verb (Appendix A), pa takes you into the path object,
ppp is the path type
path type and its name, and pathname is the user defined name
for the path.
To modify an existing PPP path, use the same syntax as above, but
replace the new verb with the mod verb. mod is the MTD for the
modify verb (Appendix A). For example:
box# mod pa ppp/wat1
path/ppp/wat1#
To remove a PPP path from the router, use the same syntax as
above, but replace the mod verb with the del verb. del is the MTD
for the delete verb (Appendix A). For example:
box# del pa ppp/wat1
Once you have edited or created a path, BCC moves you into the
path object. Typing i at this point lists all the path attributes.
(page 7-5), is the separator used between the
/
Working with Paths
7-17