Bay Networks NauticaRS Reference Manual page 206

NauticaRS 5.5R Reference Guide
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
6-60
mode
mode
sync
sync, async, framerelaysync
The operating mode of the device: Sync,
FrameRelaySync, or Async.
Use Sync for establishing connections to other Nautica
or PPP routers via a leased circuit connection.
If attaching to a frame relay network, either directly or
via a leased circuit, FrameRelaySync must be selected.
Async must be used if a V24 WIM module has been
installed and connected to an external modem.
speed
sp
64000
A valid speed
The speed, in bits/second, of the interface. Changing this
parameter does not change the actual device speed,
which is determined by the attached DCE clock rate.
This parameter should be altered to allow the correct
device speed to be displayed in all the relevant status
screens.
Note: To operate with the new settings, the device must be
powered off and on after changing the WAN device speed. Also,
if you are using the Manager port, the speed of the serial port
must be set at the speed of the WAN port.
117237-E Rev.00