Bay Networks NauticaRS Reference Manual page 600

NauticaRS 5.5R Reference Guide
Appendix B-12
c. Follow the prompts on the screen to load the new code.
The file to load is marlin.bay and is located in the default
Nautica Wizard directory (usually Program Files/Bay
Networks/Nautica Wizard).
8. Load new ISDN module code
If your Marlin has been working with no errors, then there is
no need to upgrade to the new ISDN module code. If you
have been experiencing problems, or are preparing a unit for
installation at a customer site, it is recommended that you
upgrade to the new ISDN code.
With the Marlin running the new Nautica router software,
connect to the Manager port using the adaptor and cable
provided, and issue the following command from the BCC
prompt to put the ISDN module into bootmode:
bcc> %taprog% n
Where is replaced by a digit as per the following table:
n
Number Description
1 BRI module on the baseboard
2 1st BRI module on the expansion card, or a PRI
expansion card
3 2nd BRI module on the expansion card
Execute the following command from the DOS prompt:
c:> isdnprog filename
Where filename is the name of the ISDN firmware.
Caution: If the ISDNPROG fails for any reason, do not power
off or reboot the MArlin, instead run the ISDNPROG command
again.
117237-E Rev.00