Bay Networks NauticaRS Reference Manual page 117

117237-E Rev.00
• If the commands you are typing to configure an object are too
long to fit on one line, typing
next line of the command without executing any commands
typed so far. Pressing enter by itself actions all lines of a
command.
box# new wi Remote_Server/group\
box# /static
[Save] wins/Remote_Server/group/static#
In this example, the information needed to enter a new WINS
entry (Chapter 16) is too long to fit on one line. The
the command to wrap to the next line without the command
being run. When enter is pressed without the
static attribute) the command is run and the unit moves into
the new WINS entry.
• Where possible, use the MTCs and MTDs for command lines
rather than the full command.
• Exiting the Manager without quitting (due to a computer
crash perhaps) does not save changes or reboot the unit.
When you log into the unit again, you are returned to the
same prompt you were at when the system exited early
(unless you are using telnet; then you have to log in again).
Changes are only be lost if the unit has been powered down
and up after exiting.
Configuration Options
\ enter wraps the cursor to the
\ (after the
allows
\
3-21