Bay Networks NauticaRS Reference Manual page 595

Nortel nautica nauticars software: reference guide

Hide thumbs Also See for NauticaRS:

Table of Contents

117237-E Rev.00

This operation uses the Trivial File Transfer Protocol

(TFTP) over IP. The router must be on the same subnet

as the PC running Nautica Wizard.

When restoring the configuration from a file, Nautica

Wizard extracts the IP address from the file and configures the

unit via a special protocol. After this initial step, the rest of the

configuration is loaded into the unit via TFTP. TFTP requires

that the PC and the unit are in the same subnet otherwise

communication cannot be established.

Using a Terminal Window: If Nautica Wizard is not

available, the configuration file can be restored from a

Terminal Window. To restore the configuration in this

manner, use a Telnet session (over the Ethernet) or

connect directly into the Manager port of the router.

Using BCC, enter the following at the prompts:

Batch Mode Entered

paste saved configuration file here

Config Saved

For more information on restoring and saving configuration files,

refer to Chapter 3.

Upgrading from NauticaRS 3.5R

Appendix B-7

Nauticars 5.5r