Adding And Modifying Frame Filters; Bridging And Frame Filters - Bay Networks NauticaRS Reference Manual

Adding and Modifying Frame Filters

Parameter:
MTC:
Default:
Options:
Function:
Instructions:
117237-E Rev.00
To add or create a frame filter, use the following syntax:
[co] br [new|mod] fi profnum/id
where co moves the BCC into config mode (if required), br is the
MTD for the bridge# object, new and mod are the new and
modify verbs (optional), fi is the MTD for the filter# object,
profnum is the profile group to which the filter belongs and id is
the number of the filter within the profile group.
After you have modified or created a filter, the BCC moves into
the filter object, for example:
filter/2/1#
Typing i at the filter prompt lists all the parameters for that filter.
In the table below, click on the parameter for which you require
further assistance.
profnum
id
length
offset
type
profnum
pr
Set at time of creation
A value from 1 to 5
Specifies the profile number of the filter group. Nautica
Wizard allows you to have up to five filter groups, and
each group can have up to 99 filters.
Enter a number to distinguish this group of frame filters.

Bridging and Frame Filters

enabled
action-on-match
andnext
mask
value
12-3